The television set must be connected to a VHF antenna not to a cable for this to work. 1.) Turn power on. 2.) Select channel two. 3.) Adjust contrast to maximum. 4) Lower brightness fifty percent. Once the TV is set you may see changes in your screen if a UFO is near by such as: a.) Two or three intermittent white horizontal lines that sometimes move to the top of the screen b.) Flashing ripples occassionally strange letters or writing c.) Diagonal streaks of light d.) Screen will glow stark white NOTE: The audio may also be affected by a UFO. As television is a visual medium, optimal results are obtained by observing the interactive clash between broad spectrum electromagnetic noise and an "occupied" channel two at 55.25 megacycles. With higher channels above the 100-megacycle range, most interference becomes increasingly less effective. To make today's ultra-sophisticated television receivers more susceptible to electrical noise, simply turn the antenna so that you deliberately and slightly weaken the channel two broadcast signal. NB: The tremendous propulsion systems of the UFOs have the power generating capability equivalent to an average electrical power station. UFO's are known to effect radios, various electronic equipment, and compasses to a varying degree. The equipment will often change radio frequency, change the compass direction, create odd noises and cause the equipment act up in various ways. Often batteries or lights will drain of power and stop functioning. There are also numerous reports of aircraft instruments malfunctioning, cars stopping, and homes literally shaking as the UFOs pass over. Unusual animal behavior is also frequently noticed.